Page 1129 - Foton Workshop Manual - Aumark (BJ1099)

AXLE AND PROPELLER SHAFT - REAR DIFFERENTIAL ASSEMBLY 34-99

(f). Measure the spline clearance between the
half axle gear and the half axle assembly
with wed vice and dial indicator.
If the spline clearance exceeds the limit,
check the wear of the half axle gear and
the half axle assembly and replace them
if needed. (Refer to "Chapter 34 Axle &
Transmission Shaft - Differential Assembly,
Overhaul")

NOTICE:
Hold the output flange assembly with jawed vice after wrapping it with soft cloth, or it may
cause damage.
(g). Measure the thickness of the half axle gear and the planetary gear thrust washers.

Item Thickness Limit

Half Axle Gear Thrust washer 1.22~1.28 mm
Planetary Gear Thrust washer 0.762~0.826 mm

(h). If the thickness of the half axle gear and the planetary gear thrust washers exceeds
the limit, replace the thrust washers. (Refer to "Chapter 34 Axle & Transmission
Shaft - Differential Assembly, Overhaul")
NOTICE:
Pick up the half axle gear thrust washer with proper thickness subject to the color code.

14. Remove the differential bearing
(a). Remove the differential bearing inner rings
from the differential housing with a puller.
NOTICE:
It is important to store the differential bearing
inner ring and the differential bearing outer ring 34
together. Store them by left/right separately.

Page 1129