Page 1136 - Foton Workshop Manual - Aumark (BJ1099)

34-106 AXLE AND PROPELLER SHAFT - DRIVING GEAR

(d). Measure the driving gear startup tightening
torque with a Torque wrench again.
Startup Torque : 1.5~2.6N•m
NOTICE:
• If the startup Torque is still below the limit, repeat
Steps (c)~(d) until it reaches the required range.
• If the nut Torque exceeds the maximum value
while the driving gear startup Torque is still
below the limit, replace a new driving gear
bearing sleeve. (Refer to "Chapter 34 Axle &
Transmission Shaft - Driving Gear, Overhaul")

Page 1136