Page 2106 - Foton Workshop Manual - Aumark (BJ1099)

62-54 DIAGNOSIS-POWER WINDOW

Is the inspection result normal?
Yes>To step 4.
No >Repair or replace the harness.

4. Check harness and connector (Driver door power window motor-grounding)

(a). Ignition switch:"LOCK".
(b). Unplug the driver door power window motor J01.

(c). Measure the resistance with the multimeter.
Standard resistance: (check whether there
is an open circuit)

Connect the pin by Standard value
multimeter
J01(4) - grounding ＜ 2 Ω

Is the inspection result normal?
Yes>To step 5.
No >Repair or replace the harness.

5. Check driver door control switch assembly

(a). Ignition switch:"LOCK".

(b). Replace with a new driver door control
switch assembly, and connect the vehicle
diagnostic device to the vehicle diagnose
interface.
(c). Ignition switch:"ON"，read the DTC and
observe the vehicle symptom with the
vehicle diagnostic device.

fuwx62176

Check whether the fault code and symptom exist?
Yes>To step 6.
No>Replace the driver door control switch assembly.

Page 2106