Page 2120 - Foton Workshop Manual - Aumark (BJ1099)

62-68 DIAGNOSIS-POWER WINDOW

(b). Measure the driver door control switch
assembly with the multimeter.

Connect the pin Conditions Standard
by multimeter value
Left front
J04 (15) -J04(11) electric A pprox
1.2kΩ
window up
Left front
electric
J04 (15) -J04(11) ≤ 2 Ω
window
down

Is the inspection result normal?
Yes>To step 5.
No >Replace the driver door control switch assembly.

5. Check harness and connector (Driver door control switch assembly-grounding)

(a). Ignition switch:"LOCK".
(b). Unplug the driver door power window switch connector J04.
(c). Disconnect the BCM control unit connector C57.

(d). Measure the resistance with the multimeter.
Standard resistance: (check whether there
is an open circuit)

Connect the pin by Standard value
multimeter

J04(11)-Grounding ＜ 2 Ω

Is the inspection result normal?
Yes>To step 6.
No >Repair or replace the harness.

6. Check harness and connector (Left rear door power window switch-BCM control unit)

(a). Ignition switch:"LOCK".
(b). Unplug the left rear door power window switch I01.
(c). Disconnect the BCM control unit connector C57.

Page 2120