Page 2423 - Foton Workshop Manual - Aumark (BJ1099)
P. 2423

DIAGNOSIS-LIGHTING SYSTEM                               62-371

                 Symptom description:
                 Turn shift lever to the "reverse gear" position, the backup lamp at one side doesn't turn on,
                 the other side is normal.
                 △ PROMPT:
                 Take the left rear backup lamp as an example, check with the right rear backup lamp with
                 the same method.                                                                                   62


                 Diagnosis Procedure


                 1.     Check backup lamp bulb


                 (a).   Check if the LR and RR combination lamp connectors are loose and falling off.
                 (b).   Remove LR and RR combination lamp backup lamp bulb.


                                                            (c).   Connect the positive and negative
                                                                   electrode  of  bulb  into  the  positive
                                                                   and negative electrode of the battery,
                                                                   respectively to check if the bulb will light
                                                                   up.








                 Is the result normal?
                 Yes>To step 2.
                 No >Replace the bulb.


                 2.     Check the harness disconnection


                 (a).   Disconnect LR combination lamp connector N02.


                                                            (b).   Use  a  multimeter  to  measure  the
                                                                   resistance between No. 3 terminal of
                   OFF           T.S                R2
                                             2                     connector  N02  and  No.  5  terminal  of
                                N02
                                             4  5  3               connector R2.
                      1   2  3               1                     Standard resistance: (check whether there
                                     Ω                             is an open circuit)

                                                                     Connect the pin by
                                                 fuwx62 856                                  Standard value
                                                                         multimeter
                                                                        N02(3) - K04(2)            ≤ 2 Ω










                                                                                                     Page 2423
   2418   2419   2420   2421   2422   2423   2424   2425   2426   2427   2428