Page 2427 - Foton Workshop Manual - Aumark (BJ1099)
P. 2427

DIAGNOSIS-LIGHTING SYSTEM                               62-375

                 Is the result normal?
                 Yes>To step 3.
                 No >Replace the bulb.


                 3.     Check the harness disconnection
                                                                                                                    62

                 (a).   Disconnect  left rear combination lamp N02, right rear  combination lamp N05.


                                                            (b).   Use a multimeter to measure the resistance
                                                                   between No. 1 terminal of connector N02
                                                                   and the grounding.
                                                                   Standard resistance: (check whether there
                                                                   is a short circuit)

                                                                     Connect the pin by      Standard value
                                                                         multimeter
                                                                      N02(1) - Grounding           ≤ 2 Ω



                                                            (c).   Use a multimeter to measure the resistance
                                                                   between the No.1 terminal of the right rear
                   OFF           T.S
                                         Ω                         combination lamp connector N05 and the
                                                                   ground.
                                                                   Standard resistance: (check whether there
                                 N05
                                                                   is an open circuit)
                       1   2  3
                                                                     Connect the pin by
                                                 fuwx62 944                                  Standard value
                                                                         multimeter
                                                                      N05(1) - Grounding           ≤ 2 Ω

                 Is the inspection result normal?
                 Yes>Repair harness short circuit to ground between connector N02 and backup lamp relay,
                         N05 and backup lamp relay.
                 No >Repair harness short circuit to ground between connector N02 and ground, N05 and
                         backup lamp relay.
























                                                                                                     Page 2427
   2422   2423   2424   2425   2426   2427   2428   2429   2430   2431   2432