Page 2429 - Foton Workshop Manual - Aumark (BJ1099)
P. 2429

DIAGNOSIS-LIGHTING SYSTEM                               62-377

                 Symptom description:
                 Turn combination switch to "Small light" position, the position lamp at one side doesn't turn
                 on, the other side is normal.
                 △ PROMPT:
                 Take LF position lamp as the example, use the same method to check other position
                 lamps.                                                                                             62


                 Diagnosis Procedure


                 1.     Check position lamp bulb


                 (a).   Check if the LF combination lamp connector is loose and falling off.
                 (b).   Remove LF combination lamp position lamp bulb.


                                                            (c).   Connect the positive and negative
                                                                   electrode  of  bulb  into  the  positive
                                                                   and negative electrode of the battery,
                                                                   respectively to check if the bulb will light
                                                                   up.










                 Is the result normal?
                 Yes>To step 2.
                 No >Replace the bulb.


                 2.     Check the harness disconnection


                 (a).   Disconnect LF combination lamp connector A28, body controller C54.


                                                            (b).   Use a multimeter to measure the resistance
                                                                   between No. 3 terminal of connector A28
                                                                   and No. A5 terminal of connector C54.
                                                                   Standard resistance: (check whether there
                                                                   is an open circuit)

                                                                     Connect the pin by      Standard value
                                                                         multimeter
                                                                       A28(3) - C54(A5)            ≤ 2 Ω

                 Is the inspection result normal?
                 Yes>To step 3.
                 No >Repair the harness disconnection between connector A28 and C54.



                                                                                                     Page 2429
   2424   2425   2426   2427   2428   2429   2430   2431   2432   2433   2434