Page 2668 - Foton Workshop Manual - Sauvana
P. 2668

62-616                       DIAGNOSIS-ENGINE CONTROL SYSTEM

           SLOW,  DULL AND  IMBALANCED  OF THE ACCELERATING

           REACTION


             Fault phenomenon                  Diagnosis logic                     Possible reasons

                                                                             • Air fuel ratio control system
                                                                               fault
                                    • Air intake system                      • Fuel supply system failure
                                    • Fuel supply system
            Slo w ,du ll  a nd      • Throttle body                          • Too  lowof  the  compression
            imbalanced of the       • Electronic accelerator pedal             pressure
            accelerating reaction                                            • Throttle body default
                                    • Injector                               • Inject failure
                                    • ECU
                                                                             • Ignition system failure
                                                                             • ECU


           Diagnosis steps
           1.     Check the motor data


           (a).   Ignition switch: LOCK。
           (b).   Connect the diagnosis tool with the fault diagnosis connector (16pins) on the lower
                   left of the dashboard.
           (c).   Ignition switch:ON, turn on the ignition switch, and start the diagnostic tool.
           (d).   Read the motor data shown on the diagnostic tool.


           Check whether the data flow is normalor not.
           Yes>To step 2.
           No> Maintenance related faults.


           2.     Check the air intake system


           (a).   Check the air intake pipe joints, gaskets, vacuum hose and the fuel steam system.
           (b).   Check whether the air filter has the filter elements blocked or not.


           Is the result normal?
           Yes> To step 3.
           No> Clean and change the default parts.


           3.     Check the idle speed


           (a).   Check whether the idle motion of the motor is normal or not.


           Is the result normal?
           Yes> To step 4.
           No> Refer to the engine phenomenon diagnostic list -Idle troubleshooting to confirm that
                  the problem no longer exists.



                                                                                                     Page 2668
   2663   2664   2665   2666   2667   2668   2669   2670   2671   2672   2673