Page 291 - Foton Workshop Manual - Tunland (AT)

DIAGNOSTICS - ENGINE CONTROL SYSTEM 04-145

(e) Ignition switch: ON.

(f) Use a multimeter to measure the voltage
between the pin 2 of inlet manifold 1 pressure
sensor connector E08 and ground.
Standard voltage
04
Multimeter connection
Standard value
pin
E08（2）- ground 4.75～5.25 V

Is the inspection result normal?

YES>To step 3.
No > Maintain or replace the harness.

3 . Check intake manifold 1 pressure sensor harness.
(a) Ignition switch: OFF.
(b) Disconnect the battery negative cable.
(c) Disconnect intake manifold 1 pressure sensor connector E08.
(d) Disconnect connector E01 of ECM.

(e) Use a multimeter to measure the resistance
between the pin 1, 4 of inlet manifold 1
pressure sensor connector E08 and the pin
70, 65 of ECM connector E01 respectively.
Standard resistance

Multimeter connection
Standard value
pin

E08（1）- E01（70） ＜10 Ω
E08（4）- E01（65） ＜10 Ω

Page 291