Page 370 - Foton Workshop Manual - Tunland (AT)

04-224 DIAGNOSTICS - ENGINE CONTROL SYSTEM

3 . Check starting motor relay R3
(a) Ignition switch: OFF.
(b) Disconnect the battery negative cable.
(c) Open the engine compartment relay box and pull out the starting motor relay R3.
(d) Check whether the starting motor relay R3 is good or not.
04
Is the inspection result normal?
YES>To step 4.

NO> Replace starting motor relay R3

4 . Replace starting motor relay R3
(a) Ignition switch: OFF.
(b) Disconnect the battery negative cable.
(c) Pull out starting motor relay R3.
(d) Connect the battery negative cable.
(e) Ignition switch: ON.

(f) Use a multimeter to measure the voltage
between the pin 1, 3 of starting motor relay
R3 and the ground respectively.

Standard voltage
F11 F12 F13 F16 F15 F14 F30 F17
F29 2 2 2 F18 A020
3 5 3 5 3 5 F19
R3 4 R13 4 R7 4 F20 Multimeter connection
1 1 1
2 Standard value
85 85
30 30 3 5 4 pin
R4 R16 R6 1
86 87 86 87
R3（1）-ground Battery voltage
R3（3）-ground Battery voltage

ftwxd041184

5 . Replace starting motor relay R3 circuit.

(a) Ignition switch: OFF.
(b) Disconnect the battery negative cable.
(c) Pull out starting motor relay R3.
(d) Disconnect the starting motor connector K005.
(e) Disconnect the gear shift mechanism P002 .

Page 370