Page 376 - Foton Workshop Manual - Tunland (AT)

04-230 DIAGNOSTICS - ENGINE CONTROL SYSTEM

(f) Use a multimeter to measure the resistance
between the pin 2, 3 of camshaft position
sensor connector E03 and the ground
respectively.

Standard resistance

04 Multimeter connection
Standard value
pin
E03（2）- ground ＞ 10 MΩ

E03（3）- ground ＞ 10 MΩ

Is the inspection result normal?
YES>To step 4.
No > Maintain or replace the harness.

4 . Replace camshaft position sensor
(a) Replace camshaft position sensor.
(b) Use a diagnostic apparatus to perform DTC verification procedures.
(c) Implement the steps to read sensor data stream.
(d) Check whether DTC exists.
Is the inspection result normal?

YES>Replace camshaft position sensor.
NO >To step 5.

5 . Replace ECM

(a) Replace ECM.
(b) Use a diagnostic apparatus to perform DTC verification procedures.
(c) Implement the steps to read sensor data stream.
(d) Verify that no DTC exists and the data are normal.

Page 376