Page 815 - Foton Workshop Manual - Sauvana

START AND CHARGING - STARTER 18A-15

8. Disassemble starter as components figure
shown
WARNING:
When removing commutator, do not lose the steel
ball mounted in the bearing ends.
(a). Using a proper control sleeve, push
and press the locating snap ring to the
overdrive clutch side, and make it separate
from the clip spring.
fuwx18A029

(b). Remove the snap spring with snap ring
pliers, then remove the locating snap ring
and overdrive clutch.

18A
fuwx18A030

9. Clean the starter parts
(a). Do not put the parts in the detergent for cleaning. If the magnet yoke, excitation
winding lead or rotor is immerged in detergent, their insulating ability is undermined.
(b). Clean starter parts with cloth.
(c). Drive parts cannot be immerged in detergent for cleaning. Before delivering out of
factory, the overdrive clutch is greased. If clean it by detergent, its grease might be
removed.
(d). Using a brush and dipping with detergent, clean drive parts then dry them with a
cloth.

10. Inspect the commutator
(a). Support the commutator with a pair of
V-shaped blocks and turn them to measure
the runout of the surface using a dial
gauge.
Standard: 0.05mm
Limit: 0.1mm

fuwx18A031

Page 815