Page 816 - Foton Workshop Manual - Sauvana

18A-16 START AND CHARGING - STARTER

(b). Measure the diameter of the commutator.
Standard: 29.4mm
Limit: 28.4mm

fuwx18A032

(c). Measure the depth of the undercut
between segments.
Standard: 0.5mm
Limit: 0.2mm

fuwx18A033

11. Inspect the brush and brush bracket
(a). Check whether it is conductive between brush plate and brush bracket, if not
conductive, it is normal.
(b). Check the commutator contact surface of each brush for abnormal roughness. Also
check the height of the brush. Replace the brush holder if the height is lower than
the limit.
Limit: 7.0mm
(c). When the contact surface of the brush is rectified or the brush holder is replaced,
recondition the contact surface with sandpaper wrapping around the commutator.

12. Inspect the overdrive clutch
(a). Make sure that the pinion can not be
turned counterclockwise and can be turned
clockwise freely.
(b). Check the pinion for abnormal ware and
damage.

fuwx18A034

Page 816