Page 53 - hp server user guide_Neat

GPU enablement kit

The server supports up to two full-length, single-width GPUs. If one processor is installed, the GPU must
be installed in PCIe slot 5. To install a GPU in PCIe slot 3, a second processor is required.

To install the component:
1. Unlock and remove the tower bezel ("Remove the tower bezel" on page 17).
2. Power down the server (on page 17).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Place the server on its side.
5. Remove the access panel (on page 18).
6. If installed, remove the PCI air baffle (on page 20).
7. Remove the system air baffle (on page 22).
8. Remove fan 1:
a. Disconnect fan cable from the connector.
b. Remove the fan.

9. Select the appropriate PCIe slot to install the GPU.

Hardware options installation 53