Page 66 - 2018 Alliance Parts Catalog USA Edition

SERVICE TIPS (USE IN CASE OF LINK TEST FAILURE)

OMNEX T300: DOWNLOAD ID CODE

Follow these steps to download the transmitter’s unique ID Code into the receiver. This will allow the receiver to establish a
Radio link with a specific transmitter.
NOTE: It is necessary to download the ID code when replacing either the transmitter or the receiver.

NOTE: When downloading a new ID to a receiver, a safety feature requires that the transmitter be in close proximity to the

receiver. This will prevent a transmitter from accidentally reprogramming a different receiver in the area.

1. Power R160        
Supply power to the receiver. The (E-Stop) light and the (Link) light will come on RED
and the (Status) light will come on GREEN    
   

    B.
A.
2. Prepare T300 A. A. B. B.
A.
B.
A. Press [E-Stop]
B. Twist CW & release [E-Stop]

A. A. B. B.
B.
A.
3. Power T300 into Download ID Mode A. A. B. B.
A. Hold [Power] switch UP
B. Press [E-Stop]
C. D.
C. Twist CW & release [E-Stop] C. A. 0 D. B.
C. 0 D.
D. Release [Power] Switch C. 0 D.
0

C. D.
0
A. SETUP B. SETUP

B.
Put R160 into Setup Mode
SETUP
A.
SETUP
4. NOTE: If left idle in Setup Mode for over 10 seconds, the receiver A. A.     B. B.        
SETUP
SETUP
SETUP
SETUP
   
will time out. The (Link) light and (Status) light will flash RED        
   
   
rapidly. To return to Setup Mode, repeat step 4.
A. SETUP B. SETUP
NOTE: The SETUP button is located inside the external (grey)
enclosure.        
A. Press & hold [SETUP] button until (Status) light goes from slow
flash to fast flash A. A. B. B.
A.
B. Release [SETUP] button. (Status) light goes to solid GREEN, A. B. ESTOP FAULT LINK STATUS ESTOP FAULT LINK STATUS
B.
(Link) light turns off ESTOP FAULT LINK STATUS
ESTOP FAULT LINK STATUS R160 LED State
R160 LED State
Download ID Code
5. A. Press [Power] switch UP and release A. R160 LED State
R160 LED State
B.
ESTOP FAULT LINK STATUS
B. (Link) light go to GREEN. Once complete, (Link) light
goes to RED as the transmitter turns off R160 LED State
1.888.870.0908 www.allianceconcretepumps.com 1.888.584.7231
Alliance Concrete Pumps Inc. will not be held liable for any loss, damage, or injury relating to these procedures.