Page 72 - Condition Monitor User Manual
P. 72
Configuring a Monitor
Figure 7-13 General Flux-S Configuration
• If the monitor settings are reported as being out of sync with the database, press the
‘Synchronize’ button.
Figure 7-14 Settings Out of Sync
7.5.2. Original GuardII Shaft Trigger Configuration
Press the ‘Flux’ button on the ribbon and then select ‘Key Phasor’. The shaft trigger
configuration is split up into 3 main areas:
• The Synchronization Signal graph shows the shaft trigger signal after it has been
detected by the hardware.
• The Shaft Trigger Signal graph shows the raw shaft trigger data and the selected
trigger threshold.
• The controls are used to manually acquire a fresh set of shaft trigger data.
66
www.irispower.com
