Page 67 - Dante Controller User Guide

Dante Controller User Guide

Channel is either muted, or receiving audio at less than -61dbFS

Channel is receiving audio between -61dbFS and 0dfFS

Channel is clipping

Which devices support channel metering?
Currently, Brooklyn II and PCIe devices support channel metering in Dante Controller. You can check your
device type in the Device Info tab.
n Connected To: Lists the Tx channel that the receive channel is currently subscribed to.
n Status: Shows the status of both primary and secondary subscriptions, using the following icons:

Subscription is OK and audio should be flowing

Subscription is unresolved - usually because the transmitting device
has been removed from the network, or is switched off

No subscription, or a subscription error

Subscription is via unicast connection

Subscription is via multicast connection

Subscriptions can show several symbols in the Status column. Common status icon combinations and
their meanings are as follows:

Unicast device successfully subscribed to a
transmitter

Redundant device successfully subscribed
on both primary and secondary via unicast

Redundant device successfully subscribed
on both primary and secondary via multicast

Redundant device successfully subscribed
on primary only via unicast. This is typically
seen when the secondary interface is not
connected

Flows
Flows are 'streams' of audio packets which supply data between devices. Flows can contain up to 4
channels of audio.
Dante devices can support a finite number of receive flows, depending on their specific hardware
configuration and firmware version.

Available Channels
The Available Channels pane lists the devices and advertised channels available on the network. Devices
that are greyed out indicate that this receiver cannot subscribe to those channels or devices. This is

Copyright © 2020 Audinate Pty Ltd. All rights reserved. -67-