Page 28 - QR CIMAR LASER SCREED

SET UP PROCEDURE
1) Start up Laser Transmitter at 6.5-7 feet above grade. Be sure the Laser Transmitter is set up in a
location that will not have anything in the way to cause interference.
2) Establish and set grade on the Grade Rod.
3) Position Machine in concrete, making sure both laser receivers are clear to the transmitter and
switch elevation control to manual.
4) Using level indicator, level the machine with Head Lift.
5) Near the laser receiver mast, place the Grade Rod ring on top of plow and hold vertical.
6) Using raise/lower elevation control, adjust height of plow until Grade Rod indicates proper grade.
7) Repeat Step #6 for opposite side and then recheck original side.
8) Once the plow is on-grade, manually lower the laser receiver (from top down) until the LED’s
indicate the on-grade signal, repeat the process for the opposite side.
9) Switch elevation control to automatic.
10) Screed approximately 6 feet then verify grade and make adjustments if required.

SHUT DOWN PROCEDURE
1) Position plow 1” from top.
2) Turn Off using key start and press e-stop button down.
3) Shut off Fuel.
4) Use pressure washer to get concrete off machine.

26