Page 27 - QR CIMAR LASER SCREED

6) Turn the engine stop switch clockwise. 7) Turn key clockwise to start, then release.

8) Move the throttle lever to the FAST
position and the screed is ready for
operation.

COLD WEATHER START PROCEDURE
1) Start the engine at a low RPM and leave running until engine is warmed (See Engine Manual).
2) Turn vibrator switch OFF.
3) Once engine is warm, propel around the job site to warm the hydraulic oil - BEFORE running the
vibrator. Do this for 10 minutes or so. If it is colder, run the machine longer.
4) Drop the engine RPM’s to approximately 1/2 throttle.
5) Run the vibrator in short bursts for 3-10 seconds.
6) Let the vibrator run for 5 minutes.

25