Page 49 - QR CIMAR LASER SCREED
P. 49

INSTRUCTIONS FOR FILLLIG DRIVE MOTOR WITH GREASE
INSTALLATION INSTRUCTIONS:
1) Rotate drive hub so hole #1 is on bottom.
2) Remove plugs from hole #1 & #2 on the drive motors with a 3/16” allen wrench.
3) Install grease fitting in hole #1 on the bottom of the drive motor.
4) Pump grease into grease fitting on the drive motor until it spills out of hole #2.
5) Reinstall middle plug and drive machine around for approximately one minute.
6) Remove middle plug and repeat step 4)
NOTE: Approximately 1.5 tubes of grease will have been injected into each drive motor.
7) Install the plug back into the bottom fill hole #1.
8) Always remove middle plug in hole #2 before pumping grease.
9) Check grease level once a month.

Instructions for greasing drive motor seals
Apply two (2) pumps of grease in all three (3)
fittings on the drive motor seals, after each
use of the screed.

                                                                              47
   44   45   46   47   48   49   50   51   52   53   54