Page 18 - QR CIMAR CONCRETE CUTTER TC3
P. 18

TC3-F400D/TEESIN/MAN/01/15                                                                    Compile by CJ

                            out.                                                     the pulley. Adjust
                                                                                     the tension by
                            6. Gear is binding.                                      engine base support
                                                                                     bolts and slot holes,
                            7. Air filter is clogged                                 and replace it if
                                                                                     needed.
                            with dust which                                      6. Check the dust on
                                                                                     driving gear. Wipe
                                                                                     off the dust on
                                                                                     driving gear and add
                                                                                     new grease.
                                                                                 7. Clean/replace the air
                                                                                     filter.

                            reduce        engine

                            performance.

                            8. Engine speed too                                  8. Check the engine

                            low.                                                 speed           with

                                                                                 tachometer.

                                                                                 Adjust/repair the

                                                                                 engine to run at

                                                                                 correct speed.

Engine is running but no    1. Engine throttle not                               1. Open the engine
rotation of the blade.          open.
                                                                                 throttle.
                            2. Drive belt is
                                loosened or broken.                              2. Adjust/replace the

                            3. Blade holding flange                              drive belt.
                                has damaged.
                                                                                 3. Inspect and replace
                            4. Sunk key on rotating
                                shaft has broken.                                flange.

                                                                                 4. Check the sunk key

                                                                                 at engine shaft, belt

                                                                                 pulley shaft, blade

                                                                                 driving shaft and

                                                                                 blade holding flange

                                                                                 and replace it with

                                                                                 new key.

Engine does not start       1. Engine oil level is                               1. Check the oil level
                                low.
                                                                                 and add oil if

                                                                                 needed.

Cutter trembles or works 1. Concrete is too thick                                1. Replace the V-belt

unevenly.                   or contained                                         with new one.

                            reinforcing bar.

                            2. V-belt loosed or                                  2. Replace the cutting
                                                                                     blade with new one.
                            worn out.

                            3. Cutting blade is

                            worn out.

                            4. Forwarding surface

                            is not flat or some of

                            For technical questions, please call +65 - 66431213                  16
                            For Products Enquiry, please call +65 - 67581211
   13   14   15   16   17   18   19   20   21   22   23