Page 15 - QR CIMAR CONCRETE CUTTER TC3
P. 15

TC3-F400D/TEESIN/MAN/01/15                                                       Compile by CJ

the longest life and lowest cost per cut are only suitable for work where chipping
is not a problem.

5.2) Dry & Wet Cutting Safety Guidelines

1. Do clean the flanges before mounting the blade and check both plates are the
         same diameter.

2. Do ensure that the blade is correct for the material being cut.

3. Do ensure that the arrow on the blade corresponds with the direction of rotation of
         the machine spindle.

4. Do ensure that the blade is in balance and running true. A blade which is out of
         balance means increase wear and even possible destruction of the saw. Ensure
         that the blade is concentric to within 0.15 mm.

5. Do ensure that the machine bearings and spindle are not worn - or blade life will
         be reduced.

6. Do use the blade with a gentle reciprocating motion - especially when cutting
         hard materials, and cut in the direction of the arrow.

7. Do only use machines which have an approved safety guard.

8. Do remove the diamond blade from the machine during transit to prevent
         accidental damage.

9. Do inspect blades frequently to detect cracks or undercutting of the steel centre
         and segments which could lead to segment loss.

                            For technical questions, please call +65 - 66431213  13
                            For Products Enquiry, please call +65 - 67581211
   10   11   12   13   14   15   16   17   18   19   20