Page 13 - QR CIMAR CONCRETE CUTTER TC3
P. 13

TC3-F400D/TEESIN/MAN/01/15                                                       Compile by CJ

1. Before starting the TC3-F400D, make sure to check the engine oil is at the suffice
    level (fig 4-1), and ensure the throttle is switched to the “minimal” position (fig
    4-9)

2. With assistance, set the concrete cutter on the ground.

3. Compress the compressor chamber (fig 4-2) then pull the recoil starter rope (fig 4-
    3) to start the engine.

(Note: Crank the engine for a few time and ensure the recoil starter is set at the
right position to achieve the right tension to provide the right torque before a
pull back. After the pull back release the recoil rope gently back.)

4. Open the control valve (fig 4-4) to let the water flow to the cutter blade for wet
    cutting.

5. Hand tighten the rear lever lock (fig 4-6) to prevent the elevating lever from
    turning freely. However, do not tighten the rear lever too much so as to allow user
    to turn the elevating lever..

6. Ensure all personnel are cleared from machine before pushing the throttle lever to
    “Full” position (fig 4-7). At this moment the cutter will start spinning at
    maximum speed. Take note: the r.p.m of the cutter is correlated to the extension
    of the throttle lever position.

7. Set the depth of the cutting by turning the elevating lever (fig 4-8). Then, fully
    lock the elevating lever by tightening the rear lever lock (fig 4-6) and grab firmly
    to the handles of the machine to control the cutting process.

8. Once the job is done. Switch to “Off” position (fig 4-9) to stop the machine.

                            For technical questions, please call +65 - 66431213  11
                            For Products Enquiry, please call +65 - 67581211
   8   9   10   11   12   13   14   15   16   17   18