Page 110 - QR KLINDEX EXPANDER850AT-RXt
P. 110
ASSEMBLY, TRANSPORTATION AND STORAGE
l WARNINGS 5.3 Moving to the site/work area
– Always position the weights in corre-
sponding positions on both sides. The appliance can be moved to the site or work area
– insert the pins (3) into the two housings ensuring in one of the ways indicated below:
that the hole at the end of the pin protrudes fully – using the radio control
from the support – manually
– lifting the appliance in the case of uneven surfaces
34
– insert the safety clips (4) into the hole of the pin and or with obstacles present. Lift the appliance using a
suitable means such as overhead crane, block and
bending them, position the end of the spring in the tackle, or forklift as described in section Unpacking
grooving on the pin head. and handling" on page 6.
4 5.3.1 Moving the appliance with the radio
control
The appliance can be moved in one of the following
ways:
– using the appliance battery energy supply. The ap-
pliance has up to 1.5 hours of autonomy if moved
using just the battery power supply (see the section
"Appliance battery" on page 15)
– with the appliance connected to the electrical power
supply (see the section "Connecting to the power
socket" on page24).
l WARNINGS
– Before moving the appliance to the
work area, make sure that the handle
grip and caster wheel are both inserted
and locked.
– The operator must be in a position and
at a total distance which allows him/her
to have a full overview of the area in the
operating range of the appliance.
– Make sure there are no people or ani-
mals within the operating range of the
appliance.
a WARNING
Avoid any steep slopes as there is the risk
the appliance could overturn.
20 www.klindex.com - Made in Italy
