Page 111 - QR KLINDEX EXPANDER850AT-RXt

ASSEMBLY, TRANSPORTATION AND STORAGE

To move the appliance to the work area using the ra-Error BActing on the radio control:
dio control, act as follows:Stop B – release the radio control emergency button
– check that the radio transmitter is connected to theError A– press the reset button once. The green TX LED im-
Stop A
appliance control plug and that the battery in theRF Busy mediately starts to flash. The yellow battery/alarm
radio control is in place and fully charged.Power LED flashes just once. After a few seconds the blue
Working RX LED starts to flash
– with the appliance battery energy supply, select – the white Busy RF LED on the radio control receiver
"Transport mode" by setting the main dial on the starts to flash
electric panel to position "1", the "Transport Mode" – press the reset button a second time after the blue
light activates RX LED has started flashing. The green TX LED stops
flashing and stays fixed on. The yellow LED stays off.
The blue RX LED stops flashing and stays fixed on
– the white Busy RF LED on the radio control receiver
stops flashing and stays fixed on, the red Stop LEDs
turn green and the Working LED activates

ON W

W RX

TX

OFF PLC GRINDING TRANSPORT ON W
12 READY
POWER OK MODE W RX

TX

OK

LOW – the radio control is now fully operational.

– with the appliance connected to the mains power If the yellow alarm/battery LED flashes, replace and
supply, select "Grinding" by setting the main dial on recharge the battery as described in the section "Re-
the electric panel to position "2", the "Grinding pow- placing the radio control battery" on page 16.
er OK" light activates
– Using the joystick, raise or lower the planetary to
OFF PLC GRINDING TRANSPORT prevent any damage to the cutters
12 READY
POWER OK MODE – select the most suitable speed on the basis of the
incline and distance to be travelled; lever up, maxi-
OK mum speed; lever in the intermediate position, me-
dium speed; lever down, minimum speed.
LOW
UP

– release the emergency button of the electric panel DOWN
by turning it to the right

– the "PLC ready" light activates.

PLC GRINDING TRANSPORT
READY
POWER OK MODE

OK

LOW

www.klindex.com - Made in Italy 21