Page 44 - QR KLINDEX EXPANDER850AT-RXt

OPERATION

8.5 Assembly and changing tools – move onto the stand and using your body weight,
pull the handlebar towards you until the appliance
l WARNINGS lifts up completely

– Before performing any operation on the
appliance, make sure that the main dial
is set to “OFF” and the power cable is
disconnected.

– Before fitting or changing the tools,
make sure that the handle grip and cast-
er wheel are both inserted and locked.

l NOTICE
Before fitting the tools, make sure you
have read and fully understood the indica- – when the appliance is fully raised, rest it carefully on
tions provided in the section "Identifying the floor as shown in the figure.
the hardness of the concrete" on page
28 and that you have selected the most
appropriate tool for the operation to be
carried out. To select the correct tool, see
the section "Tool selection" on page 28.

Lifting the appliance a WARNING
To assemble and replace the tools, act as described Make sure that the appliance is in a stable
below: position before carrying out any type of
– lower the appliance fully acting on the lever switch intervention.

on the control panel To facilitate appliance lifting operations, the
– remove the caster wheel, see the section "Fitting/ weight kit can be used, positioning it in the rear
support as described in the section "Weights kit
removing the caster wheel" on page 17 (optional)" on page 19.
– lift the handlebar (1) until it reaches the position for

interventions on the planets as described in section
"Fitting and adjusting the handle grip" on page
18
– release the fastening pin (3) and lower the stand (2)
completely

1
3

2

30 www.klindex.com - Made in Italy