Page 49 - QR KLINDEX EXPANDER850AT-RXt

STARTING AND STOPPING

– the white Busy RF LED on the radio control receiver Manual mode
starts to flash – Set the switch to "MAN"
– the word “MANUAL” will appear on the display
– the display activates
SEMIAUTOMATIC
********************** PAUSE
SP: * * * * * Hz TT. * * * * *
SW: * * * * * OL: * * * * * MANUAL AUTOMATIC MANUAL TT: * * * * *
WB: * * * * * * * * * * * * * * * RESET RECORD SP: * * * * * Hz OL: * * * * *
SW: * * * * * **********
WB: * * * * *

– the white Busy RF LED on the radio control receiver MODE
stops flashing and stays fixed on, the red Stop LEDs
turn green and the Working LED activates – turn the knob to select the most appropriate rota-
tion speed of the planetary based on the type of op-
– the radio control is now fully operational. eration to be carried out (see the section "Rotation
speed and direction" on page 31)
With the main dial set to "Grinding", the message
"PLAN READY" will appear on the display. In this case, – select the direction of rotation of the planetary;
it indicates that the functions relating to the planetary -- to the left, rotation starts in an anti-clockwise di-
are active. rection
-- middle, motor off
OFF MANUAL (SET THE KEY) -- to the right, rotation starts in a clockwise direction
12 SP: * * * * * Hz TT: * * * * *
SW: * * * * * OL: * * * * *
WB: * * * * * PLAN READY SPEED STOP

If the message "PL NOT RDY" appears on the display, LEFT RIGHT
this indicates that the main dial is set to "Transport
Mode" and the functions relating to the planetary are PLANETARY
not active. In this case, set the main dial to "Grinding".
– move the appliance with the directional joystick.

OFF MANUAL (SET THE KEY)
12 SP: * * * * * Hz TT: * * * * *
SW: * * * * * OL: * * * * *
WB: * * * * * PL NOT RDY

If the yellow battery status LED flashes, replace and l NOTICE
recharge the battery as described in the section "Re- Do not use the swing in manual mode.
placing the radio control battery" on page 16. Make sure that the "OFFSET" knob is set
to "0" and the "SWING" knob has been
– Use the joystick to raise/lower the planetary so that turned fully to the left.
the tools touch and adhere correctly to the floor.
Check that the level between the appliance wheels
and the tools is correct

– select the most appropriate appliance speed based
on the type of operation to be carried out;
-- lever up, max. speed
-- lever in the intermediate position, medium speed
-- lever down, minimum speed
(see the section "Rotation speed and direction" on
page 31)
UP FAST

MEDIUM

DOWN SLOW

www.klindex.com - Made in Italy 35