Page 53 - QR KLINDEX EXPANDER850AT-RXt

STARTING AND STOPPING

– once "AUTOMATIC" mode is active, the appliance l NOTICE
will begin to record the course, the red Record LED If the wheels pass the line "2" before the
activates message “REC DONE PRESS TURN” ap-
pears on the DISPLAY, this indicates that
SEMIAUTOMATIC RECORD the working area is not large enough for
PAUSE using "AUTOMATIC" mode.

AUTOMATIC
RECORD

AUTOMATIC
RECORD
MANUAL PAUSE
RESET
MANUALMODEPLAY– when the appliance has stopped turning, the Record
RESETLED deactivates and the green Play LED activates.

– after the message “REC DONE PRESS TURN” ap- SEMIAUTOMATIC RECORD
pears on the display, the appliance can be turned PAUSE
using the “TURN LEFT” or “TURN RIGHT” buttons
PAUSE

REC TOO SHORT(SET THE KEY) REC DONE PRESS TURN MODE PLAY
SP: * * * * * Hz TT: * * * * * SP: * * * * * Hz TT: * * * * *
SW: * * * * * OL: * * * * * SW: * * * * * OL: * * * * * The appliance will work automatically, grinding the
WB: * * * * * V WB: * * * * * V entire surface to its left or right and turning inde-
pendently whenever the wheels cross the lines "1"
– line "2" represents the point at which the appli- and "2", until the operator decides to stop it. The knob
ance must turn. It is also the second of the two limit "WHEELS BALANCE" will remain active so that the
points for the recording drift of the appliance can be adjusted if required.

– wait for the wheels to pass the line "2" and press WORK AREA “A” WORK AREA “B”
the "TURN LEFT" button to turn the appliance to the TLB TRB
left letting it to work in "WORK AREA A", or press the
button "TURN RIGHT" to turn the appliance to the
right and letting it to work in "WORK AREA B". The
appliance will turn based on the "TURNING TIME"
and "OVERLAP" parameters set previously

WORK AREA “A” WORK AREA “B” 2
TLB TRB

2
1

1

www.klindex.com - Made in Italy 39