Page 55 - QR KLINDEX EXPANDER850AT-RXt

STARTING AND STOPPING

9.4 Starting in manual mode – the "PLC ready" light activates

To start and control the appliance in manual mode, OFF PLC GRINDING TRANSPORT
act as follows: 12 READY
– release the drive system present on both wheels as POWER OK MODE

describe in section Manual handling on page 7 OK
– check that the electrical cable on the handlebar (1)
LOW
is connected to the appliance control plug (2). If it
is not, disconnect the electrical cable on the radio – release the control panel emergency button turning
transmitter (3) and insert it in the dummy connector it to the right
(4). Then connect the electrical cable on the handle-
bar to the appliance control plug. EMERGENCY
STOP

3 Acting on the control panel:
1 – check the distance between the planetary and the

floor by actuating the lever to raise or lower the ap-

pliance

UP POWER
DOWN ON

42

l WARNINGS – turn the knob to select the most appropriate rota-
While connecting the electric power cable tion speed of the planetary based on the type of op-
to the connector, make sure that the pins eration to be carried out (see the section "Rotation
are not damaged in the process. Follow speed and direction" on page 31)
the indications provided in the section "
Connecting the radio transmitter" on SPEED
page 18.
– select the direction of rotation of the planetary;
– select "Grinding" by setting the main dial on the -- to the left, the planetary rotates in an anti-clock-
electric panel to position "2", the "Grinding power wise direction
OK" light activates. If the "Grinding power OK" light -- middle, motor off
does not activate, check the electrical power supply -- to the right, the planetary rotates in a clockwise
and check the relative phases direction

– release the emergency button of the electric panel RT LT
by turning it to the right

– manually move the appliance.

www.klindex.com - Made in Italy 41