Page 60 - QR KLINDEX EXPANDER850AT-RXt

TROUBLESHOOTING
11 Troubleshooting
11.1 Inverter
An inverter is installed inside the electric panel (see 4
the section "Electric panel (internal view)" on page
12), equipped with a display on which the error codes
appear in the event of a fault or malfunction.
d NO
Tampering inside the inverter or altering
its settings. The appliance is supplied with
the parameters pre-set for correct oper-
ation. Klindex S.r.l. is not liable for any
damage caused by failure to observe the
above.
f ELECTRICAL HAZARD
– The appliance operates on electricity
therefore pay careful attention there is
a risk of electric shocks which may be
fatal.
– Only qualified technicians are author-
ised to act on the inverter.
12 3 45
STOP
6 7 8 9 10 11
1 Display
To view the frequency, parameter number, etc
2 ESC key
To go back to the previous menu.
46 www.klindex.com - Made in Italy
3 Up arrow key
To scroll upwards and select parameters, set-
ting values, etc.
LO/RE light
It activates when the local actuation control is
active.
5 LO/RE key
To switch actuation control between the oper-
ator (LOCAL) and the control circuit terminals
(REMOTE).
NOTE: the LOCAL / REMOTE key works during
stoppages in automatic mode. If the operator
unintentionally switches from REMOTE to LO-
CAL, set o2-01 (LOCAL/REMOTE Key Function
Selection) to "0" (disabled) to disable the LOCAL
/ REMOTE key.
6 RESET key
To move the cursor to the right.
To reset the control after a fault.
7 RUN light
It activates when the motor is running.
8 RUN key
To switch on the appliance control.
9 Arrow down key
To scroll downwards and select parameters,
setting values, etc.
10 STOP key
To stop the appliance control.
NOTE: to stop the priority circuit. A quick stop
mode can be used by pressing the STOP key
when the unit detects a hazard. This works even
if the appliance control is in operation using a
multifunction input terminal (REMOTE is set).
To prevent a stop using the STOP key, set o2-02
(STOP Key Function Selection) to 0 (disabled).
11 ENTER key
To select all the modes, parameters, settings,
etc.
To move from one screen to the next.