Page 88 - MRF Training TJ MRF Manual Version 5 22042024 final April 24_Neat

23 Plant and Equipment Safe Systems of Work

Operating a 360 Tracked Re-handler

Operative will be externally trained and
competent and have read the RA’s and SSW’s
relevant to the job they are undertaking.
Read and understood the operators handbook
relevant to the equipment they are operating.

Staff will wear all the necessary PPE provided
and instructed.

Follow all safety instructions given and not put
themselves at risk.

Ensure that they make eye contact before
entering the danger zone of any machine or
vehicle within the working environment.

Complete a daily walk around safety Inspect the bucket or grab before
inspection of your machine that will Windows and mirrors must be use. Check your blind spots using 1 m
include checking fluid levels before adjusted and clean at all times. rule and continue to start up
completing a defect sheet-any The reversing camera and bleeper Ensure that it is fitted correctly prior
defects should be reported to your must be operational at all times to start up and all locking pin are procedure
manager and rectified as necessary. fitted corectly

Daily Checks

Basic Start Up Procedure

Ensure that your seatbelt is Start engine on slow idle for 2 Before starting the engine,
confirm that the pilot control
worn at all times. minutes before full power is Confirm that all levers and pedals shut off lever is pulled up to the
are in neutral
Start Work engaged. lock position.

Basic Shut Down Procedure

Turn engine Climb down from
Park machine in control dial to Pull the pilot Switch off the machine using
a safe area Lower the Return all the slow idle control shut off three points of
away from bucket or grab control levers to positionand run lever up into Engine, remove contact whilst
waste on a firm to the ground neutral the engine for 2 the full lock keys and lock using the handrails
the machine.
level surface minutes to cool position and steps
the engine provided.

Page 87 of 181

Reviewed April 2024