Page 58 - DRAGO GT Operators Manual

Section 6 – Adjustments

6.8 Back-feed Shield

All Drago GT corn heads come equipped with a back-
feeding shield (A) to help contain any material that
may back-feed down the combine feeder house. The
back-feed shield is adjustable up and down to
accommodate different makes of combines. The
recommended starting position of the back-feed shield
is fully raised. If back-feeding in the combine feeder
house is observed, or if ears are being thrown forward
out of the corn head the shield should be lowered until
the condition is resolved.

Note: John Deere combines require the back-feed
shield to be in the fully raised position to avoid contact
with the shield over the feeder house opening on the
combine.

Adjustment:

1) Loosen the two M10 flange nuts (B) on the left
side and the two on the right side (not shown)
of the back-feed shield.
2) Move the back-feed shield (C) up/down in the
slots to the desired position.
3) Tighten the four M10 flange nuts (B) loosened
in Step 1.

Page | 56