Page 496 - Workshop Manual - Aumark (BJ1051)
P. 496

04-352
                                                    Diagnosis- combination meter

                                                                (c)     Disconnect connector of brake (or
                                                                        clutch) fluid level alarm switch.

















   04




               (d)    Start the engine.
               Check if brake (or clutch) fluid level warning light goes out.
               Yes >   Replace brake (or clutch) fluid level alarm switch.
               No >    Go to step 2.
               2.     Checking signal circuit of brake (or clutch) fluid level warning light
               (a)    Ignition switch: OFF.
                                                                (b)     Disconnect connector of combination
                                                                        meter B032.













                                                                (c)     Use a multimeter to measure resistance
                                                                        to ground of connector pin 1 of brake (or
                                                                        clutch) fluid level alarm switch B022.
                                                                        Resistance: >1MΩ










               Is check result normal?
               Yes >   Replace combination meter assembly.
               No >    Repair signal line to ground short between connector pin 1 of brake (or clutch) fluid level
                      alarm switch B022 and connector pin 16 of combination meter B032.










                                                                                                         Page 496
   491   492   493   494   495   496   497   498   499   500   501