Page 1070 - 2006 HARLEY FLSTCI SERVICE MANUAL

8.19 Loosen trim ring screw (13) and Squeeze wire retaining clip ends to Squeeze wire retaining clip ends to 8-31 2006 Softail: Electrical

FXST and FXSTB Models Figure 8-36. See 1. remove trim ring (6). Pull wiring connector block from bulb prongs. 2. Remove rubber boot (2) from back of headlamp assem- 3. bly (4). Figure 8-35. See 4. unhook them from notches in headlamp assembly. Pivot wire retaining clip away from bulb. Replace old bulb 5. with new bulb. Assemble headlight components. See 1.29 HEADLAMP 6. ALIGNMENT to adjust light beam. FLSTC, FLSTF, FLSTN and FLST Models See Figure 8-36. Remove trim ring screw (13) and trim 1. ring (6). Be careful not to bend the two tabs that hold the top of the trim ring in place. Remove mounting ring screws (20) and mou

CAUTION The use of any other headlamp bulb, other than what is specified, could result in damage to the electrical system If either headlamp bulb filament burns out, the bulb must be discarded and a new bulb installed. Use only direct replace- ment bulbs as specified in the Parts Catalogs and 8.2 BULB NOTE When reassembling headlamp, make sure slots and tabs in headlamp, mounting ring, and trim ring are aligned. CAUTION Never touch the quartz bulb with your fingers. Finger- prints will etch the glass and cause the bulb to fail. Always wrap the bulb in paper or a clean dry cloth during 1WARNING 1WARNING The bulb contains Halogen gas un

HEADLAMP GENERAL or battery discharge. REQUIREMENTS. REMOVAL/INSTALLATION ring (6). Figure 8-35. with new bulb. ALIGNMENT to adjust light beam.

HOME handling. ous injury. 1. 2. 3. bly (4). See 4. 5. 6.