Page 1072 - 2006 HARLEY FLSTCI SERVICE MANUAL

8.20 8-33

2 2006 Softail: Electrical

4-Pin multilock connector
3 Figure 8-37. Tail Lamp: FLSTC, FLSTF, FLST Figure 8-38. Removing 2-Pin Connectors
TAIL LAMP: ALL BUT FXSTD/FLSTSC/FLSTN
1

4 1
68140-98 Bulb assembly 2 Terminal pick 2-Pin connector
Lens Base
s0615x8x 1. 2. 3. 4. d0307x8x 1. 2.

Remove two screws and lens from Depress locking tab and remove 4-Pin multilock connec- Rotate bulb socket 1/4 turn in a counterclockwise direc- tion and remove from tail lamp assembly. Gently pull bulb bulb with ELECTRICAL CONTACT GREASE (Part No. 99861-90). Install new bulb in socket. Install new bulb into socket. Insert socket into tail lamp assembly and rotate 1/4 turn in a clockwise direction Connect 4-Pin multilock connector to circuit board Install lens to base with two screws. Tighten screws to 1WARNING 1WARNING Be sure that all lights and switches operate properly before operating motorcycle. Low visib
the other models. These models also use a different mini-har-
tail lamp that uses a mini harness and circuit board to simplify
FLSTC, FLSTF and FLST Softail models are equipped with a
but the lens and base are oriented 180 degrees different from
The FXSTS, FXST and FXSTB use the same type assembly,

GENERAL replacement. ness than the other models. BULB REPLACEMENT Figure 8-37. See base. tor from circuit board. from socket. new Coat base of 20-24 in-lbs (2.3-2.7 Nm). result in death or serious injury. (00316a) BASE REPLACEMENT PART NO. HD-41475-100 Remove two screws and lens from base. tor from circuit board. Pin Power In connector from circuit board. board from base. Remove base from rear fender.

HOME 1. 2. 3. 4. 5. 6. 7. 8. 1. 2. 3. 4. 5.