Page 1077 - 2006 HARLEY FLSTCI SERVICE MANUAL

3 1 2
Figure 8-48. Tail Lamp Figure 8-49. License Plate Support

2 License plate support
Fasteners (2) Plastic covers

1 Grommet fasteners

10760 1. 2. 3. 10761 1. 2.

Remove plastic covers (3) from tail If license plate support (1) was removed, install clip on inside of fender and tighten fas- NOTE Before removing tail lamp wires from connector, or harness Remove tail lamp wire terminals from connectors. See B.1 AMP MULTILOCK ELECTRICAL CONNECTORS in Install new terminals into connector. See B.1 AMP MUL- TILOCK ELECTRICAL CONNECTORS in the appendix. install tail lamp, route harness through hole in fender and lubricate rubber grommet (2) with alcohol or glass cleaner. Place grommet into posi- Place tail lamp into position and install fasteners (1). Tighten fasteners to 60-90 in-lbs (6.8-10.2 Nm). Install Figu
See Figure 8-47. Disconnect tail lamp connector (2).

Figure 8-48. lamp threads. Remove fasteners (1). Push grommet (2) to outside of fender. Figure 8-49. teners (2) to 60-90 in-lbs (6.8-10.2 Nm). from fender clips, carefully note routing for reinstallation. To Figure 8-48. plastic covers (3). See Figure 8-47. Connect tail lamp connector (2). 1 2 Left rear turn signal connector [19] Tail lamp connector [93] Right rear turn signal connector [18] 2006 Softail: Electrical

See See the appendix. See tion. 10.2 Nm). and nut (5). (3.4-5.6 Nm).
HOME 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 10735 1. 2. 3. 8-38