Page 1078 - 2006 HARLEY FLSTCI SERVICE MANUAL

8.23 8-39

4 2006 Softail: Electrical

3 Figure 8-50. Auxiliary Lamp Bulb: Typical Figure 8-51. Auxiliary Lamp Bulb/Pin Housing
5
6
Trim ring fastener
2
7 Auxiliary lamp housing
1 Nesting ring Auxiliary lamp

8 Trim ring Nut Connector Bulb
AUXILIARY LAMPS: FLSTC/FLSTN
s0644x8x 1. 2. 3. 4. 5. 6. 7. 8. 9295

Loosen trim ring fastener (1) as required to pull trim ring (2) from lip of auxiliary lamp See Figure 8-51. Rotate bulb/pin housing 1/4 turn in a counterclockwise direction and remove from auxiliary See Figure 8-51. Install new bulb/pin housing in auxiliary See Figure 8-50. Place nesting ring (7) at back of auxil- Place nesting ring over edge of lamp housing (5). Rotate nesting ring until index tab engages slot at bottom of Holding nesting ring in place, rotate auxiliary lamp so Install trim ring (2) over lip of lamp housing. Rotate trim ring so that fastener (1) is centered at bottom, and then

AUXILIARY LAMP BULB Figure 8-50. Disconnect auxiliary lamp connector (4) from bulb (6). Remove nesting ring (7) at back of auxiliary lamp (8). 1WARNING 1WARNING The bulb contains Halogen gas under pressure. Wear adequate eye protection and handle the bulb carefully. Inadequate safety precautions could result in death or lamp. Discard bulb/pin housing. CAUTION Never touch the quartz bulb with your fingers. Finger- prints will etch the glass and cause premature bulb fail- ure. Always wrap the bulb in paper or a clean dry cloth lamp and rotate 1/4 turn in a clockwise direction. iary lamp (8) with the concave side up. Connect auxiliary

HOME Removal See 1. housing (5). 2. 3. serious injury. 4. Installation during handling. 1. 2. 3. 4. lamp housing. 5. 6.