Page 1101 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 1101

3           5





                                             2                     8    1                        4
                                     3
                             1                         Figure 8-75. Fuel Gauge Sender  10                     Figure 8-76. Top Plate Torque Sequence
                                               Fuel gauge sending unit                               2







                                      3            Mounting tabs                             6

               s0642x8x                        1.  Tab  2.  3.  11561  9                 7








                   See Figure 8-74. Connect top plate connector (1).









                       NOTE  install new gasket under top plate. On carbureted models, secure fuel pump harness to wir-  CAUTION Exercise care to avoid bending float rod of fuel level sender. A bent float rod will result in erroneous gauge See Figure 8-75. Install fuel gauge sending unit (1) into mounting tabs (3). Push down on sending unit until it is On carbureted models, be sure cable tie is installed fuel gauge sender unit to secure unused fuel pump harness  See  Figure 8-76.  Place gasket and top plate on tank. Using the pattern shown, tighten T20 TORX screws to Attach fuel gauge sending unit connector [86]. All but FXSTDI, Make sure console fastener is install


              INSTALLATION  Do not apply any type of sealant to gasket.  ing at base of sending unit.   seated in tabs.  18-24 in-lbs (2.0-2.7 Nm).  Install instrument console.  Nm).  SOLE: FXSTD.  Connect negative battery cable.  or serious injury. (00070a)  Install seat.  2006 Softail: Electrical







          HOME     1.        2.  3.             readings.  4.  5.  6.  7.  8.  a.      b.    9.  10.               11.                                           8-62
   1096   1097   1098   1099   1100   1101   1102   1103   1104   1105   1106