Page 1144 - 2006 HARLEY FLSTCI SERVICE MANUAL

9-17

Figure 9-20. Engine Temperature Sensor Figure 9-21. Engine Temperature Sensor Removal 2006 Softail: Fuel Injection

10390 10391

battery cable before proceeding. (00048a)

Disconnect negative battery cable. back of front cylinder. Connect ET sensor connector [90]. Pull boot over connector. See Figure 9-19. Install fuel line fitting. See Figure 9-18. Install fuel pump fuse. Connect negative battery cable. or serious injury. (00070a)
1WARNING 1WARNING prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) NOTE On some models, horn may have to be removed to ease See Figure 9-20. Pull back boot to reveal ET sensor at Unplug ET sensor connector [90] by pulling external latch outward and using rocking motion to remove. See Figure 9-21. Loosen ET sensor using socket. When sensor starts to turn easily, finish removing by hand. Hand start new ET sensor into cylinder head bore 2-3 Tighten sensor to 10-15 ft-lbs (13.6-20.3 Nm). 1WARNING 1WARNING After installing seat, pull upward on front of seat to be sure it is in locked position. Whi

HOME To 4. removal/installation. 5. 6. 7. INSTALLATION 1. turns. 2. 3. 4. 5. 6. 7. Install seat. 8.