Page 1226 - 2006 HARLEY FLSTCI SERVICE MANUAL

3-15

Plastic capsule Spring seat Plastic capsule Valve stem seal 2006 FLSTFSE 2 : Engine

Figure 3-16. Install Plastic Capsule Figure 3-17. Install Valve Stem Seal CAUTION Failure to install plastic capsule will cause the valve stem seal to catch the edge of the valve stem keeper groove. The resulting damage will lead to leakage around the valve stem, excessive oil consumption and valve sticking. See Figure 3-16. Push on bottom of valve until it con- tacts the valve seat. Placing finger at bottom of valve to keep valve seated, slide plastic capsule over valve stem tip and keeper groove or wrap scotch tape around valve stem at keeper groove to protect seal lip. See Figure 3-17. Apply a very thi

d0179x3x d0180x3x
11. 12.

SPECIALTY TOOL Valve stem seal installer Valve spring compressor Valve guide driver tool Valve guide cleaning brush Cylinder head holding fixture Thread 12 mm end of CYLINDER HEAD HOLDING FIXTURE (Part No. HD-39786-A) into cylinder head Clamp tool in vise at a 45 degree angle or one that offers a comfortable working position. Slide spring seat over valve guide until it contacts the machined area on the cylinder head casting. Use a little grease to hold the spring seat in position, if necessary. NOTE At the time of disassembly, all parts should have been marked or tagged so that they are installed on the same Run the VALVE GUIDE CLEANING

ASSEMBLY PART NO. HD-34643-A HD-34736-B HD-39786-A Secure cylinder head for service. spark plug hole. valve (and in the same head). ness. stem into the valve guide. slides smoothly and seats properly. guide. top of the valve guide. completely free of grease and oil. of compression and valve sticking. bore.

HOME HD-34740 HD-34751 1. a. b. 2. 3. 4. 5. 6. 7. 8. 9. 10.