Page 1259 - 2006 HARLEY FLSTCI SERVICE MANUAL

8.2 Chamber 1 2 3 Figure 8-2.
Table 8-1. Front Turn Signal Lamps [31]
Figure 8-1. Front Turn Signal Connector [31]
Right Side

Wire Color Black Brown Blue (DOM) Obtain three equal lengths of strong flexible wire for use as mechanics wire. Feed wire through opening in socket terminal and then loop back twisting end until tightly Mechanics Wire Figure 8-2. Fix Mechanics Wire to Socket Terminals

Chamber 4 5 6 coiled around longer strand as shown in Repeat step with remaining socket terminals. Socket Terminal

Left Side

10115 Wire Color Blue (DOM) Violet Black 11. . f1418x2x

TURN SIGNAL BULB REPLACEMENT Locate latch slot on circumference of turn signal lamp smoked lens. Press in with small screw driver or coin to remove lens. Push bulb in and rotate 1/4 turn counterclockwise to Inspect contacts in socket. If necessary, clean contacts with a small wire brush and electrical contact cleaner. Evenly apply dielectric grease to the contacts and bottom of the new bulb. Push and rotate new bulb into socket. Snap-in and rotate smoked lens to position latch slot on FRONT TURN SIGNALS See 2.16 SEAT. Remove seat. 11WARNING 1WARNING prevent accidental vehicle start-up, which could cause death or serious injury, disconnect ne

HOME 1. 2. remove. 3. 4. 5. 6. bottom. Removal 1. To 2. 3. 4. 5. 6. 7. 8. 9. 10. 8-2