Page 1266 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 1266

8-9







              Mate console wiring connector [39]. Replace instrument console. See SPEEDOMETER ALL BUT: FXSTD in Softail Models Service Manual. Connect negative battery cable to battery.  11WARNING 1WARNING After installing seat, pull upward on front of seat to be sure it is in locked position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070a)  See 2-17 SEAT. Install seat.  Test front brake lever for pressure and operation.  Turn throttle and idle adjustors out. Test for correct oper- ation. Adjust as required. See THROTTLE CABLES in Softail Models Service Manual. Turn the ignition/light key switch
















              27.  28.  29.            30.  31.  32.  33.  34.



                                                                   CHAMBER NO.  1  2  3  4  5  6




              Verify that socket will not back out of chamber. Tug on the  Snap tapered end of locking wedges into socket hous-  Repeat for right [22] and left hand control [24] connec- tors. See DEUTSCH ELECTRICAL CONNECTORS in Refer to Table 8-3. Insert multilock socket terminals into corresponding numbered chambers of turn signal lamp multilock connector [31B] until it snaps into place. The  Gently tug on wire ends to verify that all terminals are  Rotate the hinged secondary lock inward until tabs fully If required, carry handlebars with wiring harness, switch housings and turn signals to motorcycle and install. See Replace hand control brackets and switch hou




                wire to confirm that is locked.  NOTE An ELECTRICAL  TERMINAL CRIMP  TOOL (Part No. HD- 39965) can be used to install Deutsch pin and socket termi- Install internal seals on lip of socket housings.   NOTE If the locking wedge does not snap into position, verify that all terminals are fully seated in the socket housing.  Softail Models Service Manual.  slot in terminal must face tang in chamber. Table 8-3. Turn Signal Lamp Multilock [31]  WIRE COLOR  Black (BK)  Brown (BN)  Blue (BE)  Blue (BE)  Violet (V)  Black (BK)  NOTE An ELECTRICAL  TERMINAL CRIMP  TOOL (Part No. HD- 41609) can be used to install multilock socket terminals on  engage latches on










          HOME  14.       nals on bare wires.  15.  16.  ings.  17.  18.  HAND  Right  Left  19.  locked.  bare wires.  20.  21.  22.  23.  24.  clips.  25.  26.
   1261   1262   1263   1264   1265   1266   1267   1268   1269   1270   1271