Page 470 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 470

B-7 Appendix B


                               Figure B-10. Deutsch Connector Pick Tool



                                 (Part No. HD-41475-100)  Lock tab  Lock bar  Pin housing      Attachment clip             Attachment clip installed  Figure B-11. Attachment Clip Installation See Figure B-11. Fit the attachment clip to the pin hous- ing, if removed. Place large end of slot on attachment T-stud on frame. Push assembly forward to












                                             5893                        5892                         5891                                    clip over  engage small end of slot.

               h41475-100

                                                                                                                                         2.

                                             The












              NOTE An ELECTRICAL  TERMINAL CRIMP  TOOL (Part No. HD- 39965) is used to install Deutsch pin and socket terminals on terminals must be installed, see Crimping Fit wire seal into back of pin housing. Grasp crimped pin approximately 1.0 in. (25.4 mm) behind the contact bar- rel. Gently push pins through holes in wire seal into their respective numbered locations. Feed pin into chamber until it “clicks” in place. Verify that pin will not back out of chamber; a slight tug on the wire will confirm that it is Insert tapered end of secondary locking wedge into pin housing and press down until it snaps in place.  wedge fits in the center groove within the pin








                     new  Instructions in this section.  properly locked in place.  installed position.  on the pin side.  engage the other latch.


          HOME       wires. If   3.       4.           ●         ●                   1.                                          ries, are black.         same.
   465   466   467   468   469   470   471   472   473   474   475