Page 680 - 2006 HARLEY FLSTCI SERVICE MANUAL

2.12 2 2-31

Figure 2-41. Marking Spoke Groups Figure 2-42. Check Laced Hub Offset Dimension (Rear Wheel Shown)
3 2006 Softail: Chassis

1

4
1464 TRUING d0475x2x

TRUING LACED WHEEL
SPECIALTY TOOL Divide the wheel spokes into four WHEEL

Wheel truing stand Spoke wrench The rim must be trued both laterally and radially. If new bear- ings were installed, wheels may be trued with only the bear- groups of four and mark the center of each group with a piece of tape. The groups should be directly across from one another and approximately 90˚ apart. Tighten the spokes in these four groups finger tight. Place wheel in STAND (Part No. HD-95500-80). Tighten arbor screws so hub will turn on its bearings. Lay a straightedge across hub brake disc flange and one of the marked spoke groups. Measure distance “A” from the straightedge to the location shown in Figure 2-43.

GENERAL PART NO. HD-99500-80 HD-94681-80 ings and center spacer installed. LATERAL TRUING Figure 2-41. See Leave all other spokes loose. Figure 2-42. See

HOME 1. 2. 3. 4.