Page 700 - 2006 HARLEY FLSTCI SERVICE MANUAL

2-51

Figure 2-65. Master Cylinder Assembly 2006 Softail: Chassis

s0371x2x

Stand master cylinder assembly upright on banjo sealing
surface. For best results, suspend reservoir over edge of
table. Be sure to lay down a clean shop cloth to protect
hand pressure only. Cartridge body is fully installed when
Insert cartridge body into reservoir adapter indexing tab
Wipe bore of reservoir adapter with D.O.T. 4 BRAKE
on adapter in slot on threaded end of cartridge. Use
reservoir adapter contacts large retaining ring.

the sealing surface from damage. See Figure 2-65. Install spring over push rod and car- tridge body until it contacts side of large retaining ring. Place concave side of spring retainer over end of spring fitting inside tabs in slot of clevis. Slide dust boot over spring and spring retainer. Place large flat washer on top of dust boot fitting inside Push down on large flat washer to compress spring. While holding spring in a compressed state, install new retaining ring in groove of clevis. Pull down dust boot as necessary to seat over lip on res- Rotate boot so that hole is at the bottom. Bottom is the side opposite the index tab

FLUID. tabs in slot of clevis. ervoir adapter.

HOME 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18.