Page 954 - 2006 HARLEY FLSTCI SERVICE MANUAL

4.11 4-29

If necessary, attach muffler support (19) to frame using screws (18). Tighten to 35-45 ft-lbs (47.5-61.0 Nm). NOTE Replacement cylinder head exhaust port gaskets (3) are tapered internally. Be sure the tapered side is facing exhaust pipe. Also check condition of retaining ring (4) before installa- Install new gaskets (3) in both the front and rear cylinder heads with the tapered side facing exhaust pipe. Position ends of exhaust pipe into front and rear cylinder head exhaust ports placing holes in exhaust manifold clamp (5) over cylinder head exhaust studs. Loosely Loosely install screws (23) and washers (22) to attach exhaust system

Exhaust System 1. tion. 2. 3. thread on flange nuts (6). 4. 5. (14). 6. backwards. a. b. Nm). c. d. 7. ft-lbs (40.7-44.7 Nm). 8. 9. 10.

EXHAUST SYSTEM: FLSTN

See Figure 4-24. Loosen clamps (11). Apply penetrating oil to seams of mufflers (16) and cylin- Remove screws (20) from muffler brackets (21). Pull each muffler from cylinder exhaust pipe. Remove two bolts and nuts to detach right side floor- See Figure 4-24. Detach heat shields (1, 8, 9) from cylin- der exhaust pipe (2) by removing clamps (7). Remove screws (23) and washers (22) on both muffler Remove all four exhaust header nuts (6). Remove flange locknut (12) from carriage bolt (14). Detach exhaust pipe clamp (13) from the exhaust Remove mufflers and exhaust pipes as an assembly. Remove screws (18) to detach muffler support (19) fr

REMOVAL Mufflers Only der exhaust pipe (2). Exhaust System board from mount. brackets (21). bracket (15). frame if necessary. INSTALLATION Mufflers Only brackets (21).

HOME 1. 2. 3. 4. 1. 2. 3. 4. 5. 6. 7. 1. 2. 3. 4. a. b.