Page 950 - 2006 HARLEY FLSTCI SERVICE MANUAL

4.9 Tighten clamps to 45-60 ft-lbs 4-25 2006 Softail: Fuel System

DISASSEMBLY Remove front and rear mufflers as an assembly. 1. Remove two flange locknuts (18) to detach interconnect 2. tube (15) from frame. Remove muffler shield clamps (14) to detach heat 3. shields (12) from muffler. Remove muffler clamps (10) to separate mufflers (11) 4. from exhaust pipes (1, 3). Discard clamps. ASSEMBLY Install new muffler clamps (10) to attach mufflers (11) to 1. exhaust pipes (1, 3). (61.0-81.3 Nm). NOTE TORCA muffler clamps have eliminated the need for silicone or graphite tape during assembly. To ensure sealing integrity of muffler clamps, and prevent the possibility of leakage, Har- ley-Davidson recommends that m

EXHAUST SYSTEM: FXST/FLST/FLSTC/FXSTB/FXSTS

NOTE See DISASSEMBLY for removing mufflers without removing See Figure 4-22. Remove heat shields (2, 4) by opening Remove nuts (6) from front and rear cylinder head Remove four bolts (19) and washers (20) attaching muf- flers (11) to interconnect tube assembly (15). Remove exhaust system as an assembly. Check condi- tion of interconnect gaskets (13). Replace if necessary. NOTE Replacement cylinder head exhaust port gaskets (9) are tapered internally. Be sure the tapered side is facing exhaust pipes. Also check condition of retaining ring (8) before instal- Install new gaskets (9) in both the front and rear cylinder heads with the taper

REMOVAL exhaust pipes from cylinder heads. muffler shield clamps (5). exhaust studs. INSTALLATION thread on flange nuts (6). lbs (10.8-13.6 Nm). Nm). rear heat shields (2, 4).

HOME 1. 2. 3. 4. lation. 1. 2. 3. 4. 5. a. b. c. d. 6.