Page 948 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 948

4.8                                                                                        3  2  1                                                4-23 2006 Softail: Fuel System
















                       INSTALLATION See Figure 4-20. Position new gasket (12) and two new o-rings (11) on backplate. On California models, attach clean air hose to rear of  backplate. Insert two breather bolts (10) (metric) into backplate. Thread bolts loosely into each cylinder head. Final tighten bolts to 120-144 in-lbs (13.6-16.3 Nm). Insert two breather tubes (9) into the holes in back of the filter element. Place the element back into position and attach breather tubes to breather bolts. Install air filter element (6) and bracket (5). Make sure gasket (7) holes are aligned with back-  a.   plate holes. Use three TORX screws (4) to secure bracket and  b.  filter








                                                                                                 9
                                               4.
                                        3.
                                                                      6.
                                                       5.
                                  2.
                            1.
                                                                                                                                    Gasket  7.  Backplate  8.  Breather hose (2)  9.  10.  O-ring (2)  11.  Gasket  12.  Figure 4-20. Air Cleaner Assembly
                            Remove screw (1) and air cleaner Remove three TORX screws (4) and bracket (5) from fil- Gently pull both rubber breather tubes (9) from the back of the element. Remove filter element (6) and gasket (7). Replace the filter element if damaged or if filter media Gently pull breather tubes (9) from breather bolts (10) on Inspect seal ring (3) for cracks or tears. Verify that it seals Alternately back out both breather bolts (10) (metric) a few turns a time while pulling backplate (8) away from Continue previous step until breather bolts are clear. Remove backplate (8), O-rings (11) and gasket (12). Dis- card gasket. On California models, discon
                                                                                                 10
                                                                                                                        7









                      AIR CLEANER: CARBURETED  Figure 4-20.   cannot be adequately cleaned.  Check filter element. See 1.22 AIR CLEANER FILTER. tightly to backplate. Replace as required.  with damp cloth to remove dust.  11  12  8  @ 36-60 in-lbs (4.1-6.8 Nm)  Air cleaner cover  T27 TORX screw (3)  @ 40-60 in-lbs (4.5-6.8 Nm)



                       REMOVAL  See   cover (2).   ter element (6).   the backplate.  carburetor.  hose from backplate.  See Figure 4-21.  Screw  Seal ring  Bracket  Filter element




          HOME              1.   2.   3.   4.   5.   6.  7.  8.     9.        10.  11.         s0523x4x                             1.  2.  3.  4.  5.  6.
   943   944   945   946   947   948   949   950   951   952   953