Page 973 - 2006 HARLEY FLSTCI SERVICE MANUAL

6.2 PRI-

2
under
1 4.11 EXHAUST SYSTEM:

3 Figure 5-9. Starter Wires Install primary chaincase cover and fill with lubricant. See Figure 5-7. Attach starter end cover using screw. Install rear exhaust pipe. See 4.9 EXHAUST SYSTEM: FXST/FLST/FLSTC/FXSTB/FXSTS, 4.10 EXHAUST FLSTN or 4.12 EXHAUST SYSTEM: FLSTSC as appro-
Nut with washer (metric) Solenoid wire MARY CHAINCASE. SYSTEM: FXSTD/FLSTF, Connect negative battery cable.

4 Positive battery cable ring terminal Circuit breaker wire ring terminal PRIMARY CHAINCASE COVER Install oil tank. See 3.32 OIL TANK.

s0192x5x See priate.
2.
3.
4.
1.
5. 6. 7. 8. 9.

Install starter from right side of motorcycle. NOTE Be sure jackshaft coupling engages starter shaft. 1WARNING 1WARNING Be sure the starter solenoid terminal that is connected to the positive (+) battery cable is securely covered by the rubber boot. An uncovered terminal could short against other components resulting in sparks. These sparks may cause a fire or battery explosion which could result in See Figure 5-9. Attach positive battery cable (2), circuit breaker wire (3) and solenoid wire (4). Tighten nut (1) (metric) to 60-85 in-lbs (6.8-9.6 Nm). Place rubber boot See Figure 5-8. Install the two starter mounting bolts and washers. Tighten t

INSTALLATION death or serious injury. securely over terminal. mary chaincase leaks. 2006 Softail: Starter

HOME jackshaft. 5-8
1. 2. 3. 4.