Page 981 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 981

6.2 PRI-



                                under






                CAUTION The gasket between the primary chaincase cover and chaincase must be replaced each time the cover is removed. Failure to replace this gasket may cause pri- Install primary chaincase cover and fill with lubricant.



                                PRIMARY CHAINCASE COVER
                                     Connect negative battery cable.
                          mary chaincase leaks.  10.  See   MARY CHAINCASE.  11.











                                       5.4 STARTER






                                       faces jackshaft splines. Continue with   Place spring (5) inside coupling (7). Install pinion gear (4) on shaft.  Insert bolt into jackshaft (8). shaft assembly into position in inner primary.  plate and thrust washer in place.  Bend locking tab against bolt head.  2006 Softail: Starter
              ASSEMBLY/INSTALLATION



                    NOTE See Figure 5-26. When you install the coupling (7), be sure the shallow side goes toward the jackshaft. Make sure coupling is installed on the starter motor output shaft before installing jack- See Figure 5-26. If removed, insert retaining ring (9) in coupling (10). Install coupling on starter output shaft with counter bore facing jackshaft. Shallow side of coupling  Place lockplate (2) and thrust washer (3) on bolt (1). Install retaining ring (6) if removed, on shaft. Slide jack-  NOTE Be sure the lockplate tab is in the keyway. This will hold lock- Align lockplate tab and thrust washer slot with jackshaft keyway. Screw the jackshaft bolt







                             shaft assembly.  installation.                80 in-lbs (6.8-9.0 Nm).


          HOME                  1.          2.  3.  4.  5.          6.   7.   8.  9.                                                                             5-16
   976   977   978   979   980   981   982   983   984   985   986